Skip to content
English
  • There are no suggestions because the search field is empty.

Alarm handling

Alarms for planned and event-based supervision are handled either in TelluGo or in a partner application, such as a nurse call or response system. This page describes how alarms are handled in TelluGo. In a partner application, the alarm is received and closed following the partner application's own workflow, with the video stream built into that workflow.

For / Required Role: Responder

Start a shift

To see alarms in the alarm list, you need to start a shift. When you log in without an active shift, Shift settings opens.

  1. Choose the User groups you are responsible for.
  2. Select Start shift. The alarm list opens.

To change the user groups later, open Shift settings from the profile menu and select Edit shift settings. To stop receiving alarms, select End shift.

The alarm list

Go to Alarm list. It shows the ongoing alarms for the user groups in your shift, sorted in this order:

  1. Your own alarms.
  2. Alarms nobody has accepted.
  3. Alarms other personnel have accepted.
  4. Within each group, the most severe and the oldest alarms come first.

To hide alarms that other personnel have accepted, turn on Only show my and unassigned alerts.

Each alarm card shows the event, the user, the status and how long ago the alarm was triggered:

Status What it means
Untreated Nobody has accepted the alarm yet.
Accepted Someone has accepted the alarm and is shown as responsible.
Arrived The person responsible is with the user. For event alarms, the user's cameras are turned off: they raise no new alarms, and nobody can open the video stream. Read more in Deactivating cameras. For planned and unplanned supervision, the cameras stay on.
Handled remotely The person responsible dealt with the situation without going to the user.

Handle an alarm

Event-based, planned and unplanned supervision are handled with the same steps. Read more about how to start an unplanned supervision in Unplanned supervision (Planned, unplanned and continuous supervision chapter).

  1. Select Accept alarm on the alarm card. You are shown as Responsible.
  2. Select Open camera to evaluate the situation. If two-way speech is set up, you can also talk to the user through the camera. Read more in Video stream and Two-way speech.
  3. If you can't follow up the alarm, select Release alarm so someone else can take it.
  4. Select Confirm arrival when you are with the user, or Handled remotely if you dealt with it without going there.
  5. Under Log event, tick the options that describe what happened and write a Note, if needed.
  6. Select Log and close.

When you open an alarm, it also shows Important information about the user and Information about property, such as a key code, if they are registered.

Automatic release and close

If nothing happens, an alarm is released or closed automatically:

When What happens Extend
5 minutes after you accept the alarm The alarm is released and goes back to Untreated. +5 min
30 minutes after you confirm arrival The alarm is closed. +10 min
5 minutes after you handle it remotely The alarm is closed. +5 min

The countdown is shown at the top of the alarm, and you get a reminder one minute before the time runs out. Planned and unplanned supervision are not released or closed automatically. Instead, an open supervision is cancelled when a new planned or unplanned supervision is created for the same user.

Closed alarms

Closed alarms, below the alarm list, shows the alarms closed in the last 24 hours, in the tabs Yours and All. Select an alarm to see its notes and times.

Good to know

  • If someone tries to activate the camera in Users after arrival is confirmed, TelluGo shows A responder is with the user before the camera is turned on. Read more in Deactivating cameras.
  • Only the person responsible can extend the time before an alarm is released or closed. Extending after arrival also keeps the cameras off for longer.
  • Technicians can review past alarms in the alarm history. Read more in Alarm history.
  • For partner applications, read more in Video stream and Two-way speech.